History of radar

History of radar

The history of radar starts with experiments by Heinrich Hertz in the late 19th century that showed that radio waves were reflected by metallic objects. This possibility was suggested in James Clerk Maxwell's seminal work on electromagnetism. However, it was not until the early 20th century that systems were able to use these principles were becoming widely available, and it was German inventor Christian Hülsmeyer who first used them to build a simple ship detection device intended to help avoid collisions in fog . Numerous similar systems were developed over the next two decades.

The term RADAR was coined in 1940 by the United States Navy as an acronym for radio detection and ranging; this was a cover for the highly secret technology. Thus, a true radar system must both detect and provide range (distance) information for a target. Before 1934, no single system gave this performance; some systems were omni-directional and provided ranging information, while others provided rough directional information but not range. A key development was the use of pulses that were timed to provide ranging, which were sent from large antennas that provided accurate directional information. Combining the two allowed for accurate plotting of targets.

In the 1934–1939 period, eight nations developed, independently and in great secrecy, systems of this type: the United States, Great Britain, Germany, the USSR, Japan, the Netherlands, France, and Italy. In addition, Great Britain had shared their basic information with four Commonwealth countries: Australia, Canada, New Zealand, and South Africa, and these countries had also developed indigenous radar systems. During the war, Hungary was added to this list.

Progress during the war was rapid and of great importance, probably one of the decisive factors for the victory of the Allies. By the end of hostilities, the United States, Great Britain, Germany, the USSR, and Japan had a wide diversity of land- and sea-based radars as well as small airborne systems. After the war, radar use was widened to numerous fields including: civil aviation, marine navigation, radar guns for police, meteorology and even medicine.

United States Army

As the Great Depression started, economic conditions led the U.S. Army Signal Corps to consolidate its widespread laboratory operations to Fort Monmouth, New Jersey. On June 30, 1930, these were designated the Signal Corps Laboratories (SCL) and Lt. Colonel (Dr.) William R. Blair was appointed the SCL Director.

Among other activities, the SCL was made responsible for research in the detection of aircraft by acoustical and infrared radiation means. Blair had performed his doctoral research in the interaction of electromagnet waves with solid materials, and naturally gave attention to this type of detection. Initially, attempts were made to detect infrared radiation, either from the heat of aircraft engines or as reflected from large searchlights with infrared filters, as well as from radio signals generated by the engine ignition.

Some success was made in the infrared detection, but little was accomplished using radio. In 1932, progress at the Naval Research Laboratory (NRL) on radio interference for aircraft detection was passed on to the Army. While it does not appear that any of this information was used by Blair, the SCL did undertake a systematic survey of what was then known throughout the world about the methods of generating, modulating, and detecting radio signals in the microwave region.

The SCL's first definitive efforts in radio-based target detection started in 1934 when the Chief of the Army Signal Corps, after seeing a microwave demonstration by RCA, suggested that radio-echo techniques be investigated. The SCL called this technique radio position-finding (RPF). Based on the previous investigations, the SCL first tried microwaves. During 1934 and 1935, tests of microwave RPF equipment resulted in Doppler-shifted signals being obtained, initially at only a few hundred feet distance and later greater than a mile. These tests involved a bi-static arrangement, with the transmitter at one end of the signal path and the receiver at the other, and the reflecting target passing through or near the path.

In 1936, W. Delmar Hershberger, SCL’s Chief Engineer at that time, started a modest project in pulsed microwave transmission. Lacking success with microwaves, Hershberger visited the NRL (where he had earlier worked) and saw a demonstration of their pulsed set. Back at the SCL, he and Robert H. Noyes built an experimental apparatus using a 75 watt, 110 MHz (2.73 m) transmitter with pulse modulation and a receiver patterned on the one at the NRL. A request for project funding was turned down by the War Department, but $75,000 for support was diverted from a previous appropriation for a communication project.

In October 1936, Paul E. Watson became the SCL Chief Engineer and led the project. A field setup near the coast was made with the transmitter and receiver separated by a mile. On December 14, 1936, the experimental set detected at up to 7 mi (11 km) range aircraft flying in and out of New York City.

Work then began on a prototype system. Ralph I. Cole headed receiver work and William S. Marks lead transmitter improvements. Separate receivers and antennas were used for azimuth and elevation detection. Both receiving and the transmitting antennas used large arrays of dipole wires on wooden frames. The system output was intended to aim a searchlight. The first demonstration of the full set was made on the night of May 26, 1937. A bomber was detected and then illuminated by the searchlight. The observers included the Secretary of War, Henry A. Woodring; he was so impressed that the next day orders were given for the full development of the system. Congress gave an appropriation of $250,000.

The frequency was increased to 200 MHz (1.5 m). The transmitter used 16 tubes in a ring oscillator circuit (developed at the NRL), producing about 75 kW peak power. Major James C. Moore was assigned to head the complex electrical and mechanical design of lobe switching antennas. Engineers from Western Electric and Westinghouse were brought in to assist in the overall development. Designated SCR-268, a prototype was successfully demonstrated in late 1938 at Fort Monroe, Virginia. Production of SCR-268 sets was started by Western Electric in 1939, and it entered service in early 1941.

Even before the SCR-268 entered service, it had been greatly improved. In a project led by Major (Dr.) Harold A. Zahl, two new configurations evolved – the SCR-270 (mobile) and the SCR-271 (fixed-site). Operation at 106 MHz (2.83 m) was selected, and a single water-cooled tube provided 8 kW (100 kW pulsed) output power. Westinghouse received a production contract, and started deliveries near the end of 1940.

The Army deployed five of the first SCR-270 sets around the island of Oahu in Hawaii. At 7:02 on the morning of December 7, 1941, one of these radars detected a flight of aircraft at a range of 136 miles (219 km) due north. The observation was passed on to an aircraft warning center where it was misidentified as a flight of U.S. bombers known to be approaching from the mainland. The alarm went unheeded, and at 7:48, the Japanese aircraft first struck at Pearl Harbor.

World War II radar

At the start of World War II in September 1939, both the United Kingdom and Germany knew of each other's ongoing efforts in radio navigation and its countermeasures – the "Battle of the beams". Also, both nations were generally aware of, and intensely interested in, the other's developments in radio-based detection and tracking, and engaged in an active campaign of espionage and false leaks about their respective equipment. By the time of the Battle of Britain, both sides were deploying range and direction-finding units (radars) and control stations as part of integrated air defense capability. However, the German Funkmessgerät (radio measuring device) systems could not assist in an offensive role and was thus not supported by Adolf Hitler. Also, the Luftwaffe did not sufficiently appreciate the importance of British Range and Direction Finding (RDF) stations as part of RAF's air defense capability, contributing to their failure.

While the United Kingdom and Germany led in pre-war advances in the use of radio for detection and tracking of aircraft, there were also developments in the United States, the Soviet Union, and Japan. Wartime systems in all of these nations will be summarized. The acronym RADAR (for RAdio Detection And Ranging) was coined by the U.S. Navy in 1940, and the subsequent name "radar" was soon widely used.